AMCC 3WARE 9650SE Installationsanleitung PDF herunterladen (Seite 19)

www.3ware.com 15

Chapter 2. Installing

Your 3ware RAID

Controller

Tools You Need

You will need the following tools during installation:

 An ESD grounding strap or mat

 A Phillips screwdriver

Before You Start

3ware 9650SE RAID controllers can be installed in a standard

enclosure or in an enclosure with a backplane.

1 Be sure to read “Safety Information” on page 10 in Chapter 1.

2 If you have a Battery Backup Unit (BBU), install it on the

controller before proceeding. For details, see

“Chapter 3.

Installing the Battery Backup Unit”.

3 If appropriate, set the PM2 (power management) jumper on the

disk drives, to enable staggered spinup. Check the

documentation that came with your disk drives to see whether

this is required.

4 SATA-2 hard drives are sometimes shipped from the

manufacturer with the transfer rate set to 1.5Gbps. If this is the

case for your drives, you may need to remove a jumper or run a

software utility to change the transfer rate to 3.0Gbps,. Please

check with your hard drive manufacturers documentation or

website on how to set the transfer rate to 3.0Gbps.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 44 45

Keine Kommentare

AMCC 3WARE 9650SE Installationsanleitung Seite 19