AMCC 9690SA Bedienungsanleitung PDF herunterladen (Seite 23)

Chapter 3. Installing a Battery Backup Unit

19 3ware 9690SA SAS/SATA RAID Controller Installation Guide

3 Press down gently until the BBU is seated.

Figure 12. BBU control module connected to the controller

4 Turn the controller over, insert the plastic screw head that you

removed in step 1 into the plastic post, and tighten it gently but

firmly. (Do not over-tighten!)

5 If necessary, attach the extension cable to the BBU control

module in order to reach the intended location of the remote

battery board.

6 Install your 3ware RAID controller. Refer to “Chapter 2.

Installing Your 3ware RAID Controller” on page 10 for details.

Installing the Remote Battery

1 Remove the metal filler brackets for the expansion slot in

which you have decided to install the remote battery board.

Save the screws; they will be used to secure the remote battery

board after you have installed it in the slot.

2 If your enclosure is low-profile, unscrew the full height bracket

from the remote battery board and replace it with the included

low-profile bracket, using the same screws.

3 Select the battery location on the remote battery board.

The battery can be mounted in 3 different positions, as marked

on the board (see Figure 13). Use the position that will make it

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Keine Kommentare

AMCC 9690SA Bedienungsanleitung Seite 23