AMCC 3WARE 9590SE Betriebsanweisung PDF herunterladen (Seite 103)

Enclosure Object Commands

www.3ware.com 97

/cx/ex/pwrs

set identify=on|off

This command is used by 9690SA controllers.

This command causes the power supply to be identified by blinking the LED

associated with it, or turns off identification of the LED for this power supply.

Setting identify to on will cause the LED associated with that power supply to

blink.

Example:

//localhost> c0/e0/pwrs1 set identify=on

Sending Identify request to Power Supply c0/e0/pwrs1 to [on] ...

Done.

/temp

show

This command is used by the 9690SA controller.

This command shows the information about the specified temperature sensor

element /fanx in the specified enclosure cx/ex. The possible status values are

OK, OVER-WARNING, OVER-FAIL, UNDER-WARNING, UNDER-FAIL,

where OVER denotes over-temperature and UNDER denotes under-

temperature. For more information about these statuses, see the 3ware Serial

ATA RAID Controller User Guide

Example:

//localhost> /c0/e0/temp0 show

TempSensor Status Temperature Identify

--------------------------------------------------------

temp0 OK 42C(107F) Off

/cx/ex/temp

show identify

This command is used by 9690SA controllers.

This command shows the identify status of the specified temp sensor. The

status can be either on or off.

Example:

//localhost> c0/e0/temp1 show identify

c0/e0/temp1 Identify status = on

/cx/ex/temp

set identify=on|off

This command is used by 9690SA controllers.

This command causes the temp sensor to be identified by blinking the LED

associated with it, or turns off identification of the LED for this temp sensor.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 109 110

Keine Kommentare

AMCC 3WARE 9590SE Betriebsanweisung Seite 103