AMCC 3WARE 9590SE Betriebsanweisung PDF herunterladen (Seite 90)

Chapter 2. CLI Syntax Reference

84 3ware Serial ATA RAID Controller User Guide

00 00 00 00 00 00 C7 3E 00 C8 C8 00 00 00 00 00

00 00 C8 00 00 64 FD 00 00 00 00 00 00 00 CA 32

00 64 FD 00 00 00 00 00 00 00 00 00 00 00 00 00

00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00

00 00 00 00 00 00 00 00 00 00 82 00 AE 01 00 5B

03 00 01 00 01 CA 02 00 00 00 00 00 00 00 00 00

00 00 0B 01 00 00 02 07 07 07 07 06 07 07 07 00

00 00 00 00 00 00 00 01 3A 68 E2 4B 00 00 00 00

00 00 C5 AB 08 58 1D 00 00 00 00 00 00 00 00 00

00 00 00 00 3A 68 E2 4B 00 00 00 00 00 00 00 00

02 00 01 00 00 00 00 00 00 00 C5 60 F4 BC 00 00

00 00 30 00 00 00 00 00 00 00 0B 01 00 00 00 00

C4 55 00 00 00 00 00 00 00 00 00 00 00 00 00 00

00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 CC

remove [noscan] [quiet]

This command allows you to remove (or export) a port (or drive) /cx/px.

Exporting a port instructs the firmware to remove the specified port from its

pool of managed ports, but does not retain the DCB (Disk Configuration

Block) metadata on the attached disk. You can import (or re-introduce) the

port by rescanning the controller.

noscan is used to not inform the operating system of this change. The default

is to inform the operating system.

quiet is for non-interactive mode.

Warning: Use caution when using this command as this operation will degrade

any redundant units. This command will fail if you attempt to remove a drive from a

non-redundant unit. After the drive is removed in CLI it can be removed physically,

without powering down the system if a hot swap bay is available. System hangs and

damage can occur if a hot swap bay is not used.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 109 110

Keine Kommentare

AMCC 3WARE 9590SE Betriebsanweisung Seite 90