AMCC 3WARE 9590SE Betriebsanweisung PDF herunterladen (Seite 36)

Chapter 2. CLI Syntax Reference

30 3ware Serial ATA RAID Controller User Guide

/cx set stagger=nn (9000 series)

/cx set autocarve=on|off (9000 series SX/SE/SA only)

/cx set carvesize=[1024...2048] (9000 series SX/SE/SA only)

/cx set rebuild=enable|disable|1..5 (9000 series)

/cx set autorebuild=on|off (9000 series SX/SE/SA only)

/cx set autodetect=on|off disk=<p:-p>|all

/cx set verify=enable|disable|1..5 (9000 series)

/cx set selftest=enable|disable [task=UDMA|SMART](9000

series)

/cx flush

/cx update fw=filename_with_path [force] (9000 series)

/cx commit (Windows only. Also known as shutdown)

/cx start mediascan (7000/8000 only)

/cx stop mediascan (7000/8000 only)

/cx rescan [noscan]

show

This command shows summary information on the specified controller /cx.

This information is organized into a report containing two to three parts:

• A Unit summary listing all present units

• A Port summary section listing of all ports (or virtual ports) and disks

attached to them.

• A BBU summary section listing, if a BBU is installed on the controller.

The Unit summary section lists all present unit and specifies their unit

number, unit type (such as RAID 5), unit status (such as INITIALIZING), %R

(percent completion of rebuilding), % V/I/M (percent completion of

verifying, initializing, or migrating), stripe size, size (usable capacity) in

gigabytes or terabytes, and the auto-verify policy status (on/off)

Possible unit statuses include OK, RECOVERY, INOPERABLE,

UNKNOWN, DEGRADED, INITIALIZING, INIT-PAUSED, VERIFYING,

VERIFY-PAUSED, REBUILDING, REBUILD-PAUSED, MIGRATING, and

MIGRATE-PAUSED. Definitions of the unit statuses are available in the

3ware Serial ATA RAID Controller User Guide.

Note: If an asterisk (*) appears next to the status of a unit, there is an error on one

of the drives in the unit. This feature provides a diagnostic capability for potential

problem drives. The error may not be a repeated error, and may be caused by an

ECC error, SMART failure, or a device error. Rescanning the controller will clear the

drive error status if the condition no longer exists

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 109 110

Keine Kommentare

AMCC 3WARE 9590SE Betriebsanweisung Seite 36