AMCC 3WARE 9590SE Betriebsanweisung PDF herunterladen (Seite 14)

Chapter 1. Introduction to the 3ware Command Line Interface

8 3ware Serial ATA RAID Controller User Guide

Example

tw_cli /c0 show diag > /tmp/3w_diag.out

Using an input file to execute a script

You can operate 3ware CLI scripts by executing a file. The file is a text file

containing a list of CLI commands which you have entered in advance. Each

command must be on a separate line.

Syntax

tw_cli -f <filename>

Where <filename> is the name of the text file you want to execute.

Example

tw_cli -f clicommand.txt

This example executes the file clicommand.txt, and runs the CLI commands

included in that file.

Scripting examples

Following is a scripting example for a 4-port controller using a text file called

config_unit.txt, containing three commands. This example sets up a 4-port

controller with two units, each with 2 drives mirrored. It then prints the

configurations for verification. The commands included in the script file are:

/c0 add type=raid1 disk=0-1

/c0 add type=raid1 disk=2-3

/c0 show

Following is a scripting example for a 12-port controller using a text file

called config_unit.txt, containing three commands. This example sets up a 12-

port controller with two units: one with the first 2 drives mirrored, and another

with the remaining drives in a RAID 5 array. It then prints the configurations

for verification. The commands included in the script file are:

/c0 add type=raid1 disk=0-1

/c0 add type=raid5 disk=2-11

/c0 show

To run either of the scripts, enter:

tw_cli -f config_unit.txt

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 109 110

Keine Kommentare

AMCC 3WARE 9590SE Betriebsanweisung Seite 14